5.2 gpm 3200 psi Pressure Washer KEY START Skid Mounted Cold Comet Pump

5.2 gpm 3200 psi Pressure Washer Key Start / Electric Start Skid Mounted Cold Comet Pump

Strongly recommend adding the plumbing kit to this pressure washer. Add either the PL-4-TO for a tote connection or the PL-4-TA for a horizontal leg tank or regular tank. Remember to add a Hudson Float Valve (Hudson-HT) and a Hudson float assembly kit with (Hudson-A) or (HB).

5.2 GPM 3200 psi Honda GX390 13 HP Comet FW2 5030 Pump

• Powder-coated Steel Frame 
• 50 mesh stainless steel inlet filter
• External unloader to bypass back to tank if plumbed
• Low oil shutdown
• Heavy duty belt guard
• 29"L x 20" W x 20" H
• 142 lbs
• 3 Amp Charging System
• Oil pre-filled in pump and engine
• 30W Non-Detergent oil in pump
• 10W30 oil in engine 1.16 qt capacity
• Fuel tank capacity:  1.6 gal

36" gun/wand assembly with quick connects, 50' high pressure hose with quick connects, 15, 25 and 40 degree nozzles plus a black QC soap nozzle, and a chemical injector assembly with quick connects.

We highly recommend adding the best high pressure 3/8" ball valve (6292.SM) to this order to allow you to turn off the flow of water to switch from the gun to a whisper wash ultra surface cleaner (6717).  You will need 25 degree 3.5 orifice nozzles (1125) for your surface cleaner.

Choose the 6540-4 JROD & the Kyle Davis long range shooter nozzle (SN4I) for great results or add the 6540-5 and 15 and 20 orifice nozzles for lower range.

Use a 6.0 turbo nozzle for this pressure washer.

The 16" Whisper Wash Ultra is the perfect complement to this cold pressure washer because this is still a 13 HP engine powering this unit.

If supplying water from a tank, use 1" non-collapsible suction hose with a 1" Y-strainer (YS16H). We have a plumbing kit for pressure washers that includes everything needed to plumb this unit to a tank (PL-4-TA) or (PL-4-TO).

SKU:  PW.B553E

Inlet line size should be adequate to avoid starving the pump.

• Line size must be a minimum of one size larger than the pump inlet fitting.  Avoid tees, 90 degree elbows or valves in the inlet line of the pump to reduce the risk of flow restriction and cavitation.
• The line must be a flexible hose, not a rigid pipe, and reinforced on suction systems to avoid collapsing.
• The simpler the inlet plumbing the less the potential for problems. Keep the length to a minimum, the number of elbows and joints to a minimum (ideally no elbows) and the inlet accessories to a minimum.
• Use pipe sealant to assure air tight, positive sealing pipe joints
• Can not be shipped inside the state of California