2" ID Non-Collapsible Supply / Suction Hose For Pumps From Tank Sold Per Foot
2" ID non-collapsible supply / suction hose for pumps foot (per continuous foot (12")
- Inlet line size should be adequate to avoid starving the pump.
- Line size must be a minimum of one size larger than the pump inlet fitting. Avoid tees, 90-degree elbows or valves in the inlet line of the pump to reduce the risk of flow restriction and cavitation.
- The line must be a flexible hose, not a rigid pipe, and reinforced on suction systems to avoid collapsing.
- The simpler the inlet plumbing the less the potential for problems. Keep the length to a minimum, the number of elbows and joints to a minimum (ideally no elbows) and the inlet accessories to a minimum.
- Use pipe sealant to assure air-tight, positive sealing pipe joints
Hose will be slightly generously cut and sent in one continuous length unless you send a note indicating otherwise.
We carry this hose in 3/4", 1", 1.25", 1.5 and 2". We also offer this hose in a wire reinforced hose in the same hose ID's. This hose is available in a 100' run and in longer lengths in special order.
This 2" supply hose can be used with corrosive chemicals such as sodium hypochlorite and sodium hydroxide.
***Supply/suction hose inner diameter (ID) should be doubled compared to the pump inlet/suction port. For example, the General Pump TSF2021 has a 3/4" inlet on either side of the bottom manifold of the pump. The pump should be supplied with 1 1/2" non-collapsible suction hose.
Condition: New
SKU: AGC32
