5.5 gpm 3000 psi Pressure Washer Key Start Skid Mounted Cold Bandit
5.5 gpm 3000 psi Pressure Washer Key Start Skid Mounted Cold Bandit
Strongly recommend adding the plumbing kit to this pressure washer. Add either the PL-4-TO for a tote connection or the PL-4-TA for a horizontal leg tank or regular tank. Remember to add a Hudson Float Valve (Hudson-HT) and a Hudson float assembly kit with (Hudson-A) or (HB).
5.5 GPM 3000 psi Honda GX390 13 HP Comet RW5535S pump
- Aluminum frame
- 50 mesh SS inlet filter
- External unloader and bypass
- Low oil shutdown.
- Easy access two-piece belt guard
- 43"L x 26" W x 27" H
- 3-groove 'Bandit' belt for uniform tension and maximum power transfer
Empty battery box is included. Please purchase a deep cycle marine battery locally.
36" gun/wand assembly with quick connects, 50' high pressure grey hose with quick connects, 5 quick connect nozzles, high draw chemical injector assembly with quick connects.
We highly recommend adding the best high pressure 3/8" ball valve (6292.SM) to this order to allow you to turn off the flow of water to switch from the gun to a whisper wash ultra surface cleaner (6717). You will need 25-degree 3.5 orifice nozzles (1125) for your surface cleaner.
Choose the 6540-4 JROD & the Kyle Davis long range shooter nozzle (SN4I) for great results or add the 6540-5 and 15 and 20 orifice nozzles for lower range.
Use a 6.5 or 7.0 turbo nozzle for this pressure washer.
The 16" Whisper Wash Ultra is the perfect complement to this cold pressure washer because this is still a 13 HP engine powering this unit.
If supplying with a garden hose from a property, use a 3/4" ID garden hose. If supplying water from a tank, use 1" non-collapsible suction hose with a 1" Y-strainer (YS16H). We have a plumbing kit for pressure washers that includes everything needed to plumb this unit to a tank (PL-4-TA) or (PL-4-TO).
Inlet line size should be adequate to avoid starving the pump.
- Line size must be a minimum of one size larger than the pump inlet fitting. Avoid tees, 90-degree elbows or valves in the inlet line of the pump to reduce the risk of flow restriction and cavitation.
- The line must be a flexible hose, not a rigid pipe, and reinforced on suction systems to avoid collapsing.
- The simpler the inlet plumbing the less the potential for problems. Keep the length to a minimum, the number of elbows and joints to a minimum (ideally no elbows) and the inlet accessories to a minimum.
- Use pipe sealant to assure air-tight, positive sealing pipe joints
- https://www.catpumps.com/
