1.25" ID TigerFlex Blue Water Non-Collapsible Suction Tank Feed Hose Sold Per Foot
TigerFlex Blue Water 1.25" ID non-collapsible supply / suction hose for pumps foot (per continuous foot (12").
- 90 PSI Working Pressure at 68 degrees F, 65 PSI at 104 degrees
- Minimum Bend Radius at 68 degrees F 4"
- OD: 1.56"
- Inlet line size should be adequate to avoid starving the pump.
DO NOT USE this hose on the discharge side of any pump.
A FOOT PER QUANTITY SELECTED!
Line size must be a minimum of one size larger than the pump inlet fitting. Avoid tees, 90-degree elbows or valves in the inlet line of the pump to reduce the risk of flow restriction and cavitation.
The line must be a flexible hose, not a rigid pipe, and reinforced on suction systems to avoid collapsing.
The simpler the inlet plumbing the less the potential for problems. Keep the length to a minimum, the number of elbows and joints to a minimum (ideally no elbows) and the inlet accessories to a minimum. Use pipe sealant to assure air-tight, positive sealing pipe joints.
Hose will be slightly generously cut and sent in one continuous length unless you send a note indicating otherwise.
This 1.25" supply hose can be used with corrosive chemicals such as sodium hypochlorite and sodium hydroxide.
***Supply / Suction hose inner diameter (ID) should be doubled compared to the pump inlet/suction port. For example, the General Pump TSF2021 has a 3/4" inlet on either side of the bottom manifold of the pump. The pump should be supplied with 1 1/2" non-collapsible suction hose.
