
1 1/2" Hose Barb x 3/4” MPT Brass for Pump Inlet
In stock
3/4" MPT x 1 1/2" Hose Barb brass for pump inlet.
This is a very difficult hose barb to find. This will allow you to correctly plumb your 8 GPM pump with 1 1/2" non-collapsible suction hose. Don't forget to add the 1 1/2" 80 mesh filter (YS24). Before installing into your pump manifold, review the orientation of the pump. Do you need to add a street 90 in brass (2104) to allow you to connect to the water supply tank? Pick up at least four stainless steel hose clamps to install the supply hose (HC-SS).
This hard to find hose barb is part of the PL-8-TA or PL-to kit .
Check out our diagram showing you how to correctly plumb your pressure washer to a water tank.
We carry this same hose barb in SCH 80 PVC for your 1" air diaphragm pump! Look for part HB2416PVC.
Condition: New