4 gpm 4000 psi Pressure Washer Key Start Honda General Pump S/EB4040HG-E Skid Cold
4 gpm 4000 psi Pressure Washer Key Start Honda General Pump S/EB4040HG-E Skid Cold
4 GPM 4000 psi Honda GX390 13 HP V-belt on the standard powder coated steel frame, marine battery box, 50 mesh inlet filter, commercial unloader, low oil shutdown, thermal relief valve, gun/wand assembly with quick connects, 50' high pressure grey hose with quick connects, 5 quick connect nozzles, 20% high draw chemical injector assembly with quick connects.
We highly recommend adding the best high pressure 3/8" ball valve (6292.SM) to this order to allow you to turn off the flow of water to switch from the gun to a Whisper Wash 16" Ultra surface cleaner (6717).
If supplying with a garden hose from a property, use a 3/4" ID garden hose. If supplying water from a tank, use 1" non-collapsible suction hose (AGC16) with a 1" Y-strainer (YS16H).
4 GPM plumbing kit for pressure washers
Includes everything needed to plumb this unit to:
Install a high temperature Hudson float valve (Hudson-HT) using everything you need to install it with our Hudson assembly (Hudson-A) or (HB). The Hudson assembly installs into the very top of the tank using a bulkhead and garden hose connection to prevent the tank from over-flowing.
This unit is available in skid or portable cart for the same cost.
Inlet line size should be adequate to avoid starving the pump.
Line size must be a minimum of one size larger than the pump inlet fitting. Avoid tees, 90-degree elbows or valves in the inlet line of the pump to reduce the risk of flow restriction and cavitation, The line must be a flexible hose, not a rigid pipe, and reinforced on suction systems to avoid collapsing.
The simpler the inlet plumbing the less the potential for problems. Keep the length to a minimum, the number of elbows and joints to a minimum (Ideally no elbows) and the inlet accessories to a minimum. Use pipe sealant to assure air-tight, positive sealing pipe joints.